 |
 |
 |
 |
|
Product Detail |
 |
|
Brass players - say hello to your new microphone. The Audio Technica PRO 35 was specifically designed to handle the high sound pressure levels of saxophone, trumpet & other brass instruments. It also excels at toms and other percussion devices, due to its ability to accurately translate rich tones even under high levels of sound pressure. It comes with a UniMount clip that allows for positioning as well as shock resistance while protecting the microphone iteslf.
- UniMount® clip permits accurate positioning, provides shock resistance and protects element
- Cardioid polar pattern reduces pickup of sounds from the sides and rear, improving isolation of desired sound source
- Extended frequency response captures subtle nuances of the performance
- 6' (1.8 m) cable permanently attached to microphone
- ELEMENT Fixed-charge back plate, permanently polarized condenser
- POLAR PATTERN Cardioid
- FREQUENCY RESPONSE 50-15,000 Hz
- LOW FREQUENCY ROLL-OFF 80 Hz, 18 dB/octave
- OPEN CIRCUIT SENSITIVITY -45 dB (5.6 mV) re 1V at 1 Pa
- IMPEDANCE 250 ohms
- MAXIMUM INPUT SOUND LEVEL 145 dB SPL, 1 kHz at 1% T.H.D.
- DYNAMIC RANGE (typical) 115 dB, 1 kHz at Max SPL
- SIGNAL-TO-NOISE RATIO 64 dB, 1 kHz at 1 Pa
- PHANTOM POWER REQUIREMENTS 11-52V DC, 2 mA typical
- SWITCH Flat, roll-off
- WEIGHT (MICROPHONE) 0.3 oz (8 g)
- WEIGHT (POWER MODULE) 2.9 oz (81 g)
- DIMENSIONS (MICROPHONE) 0.98" (25.0 mm) long,
0.40" (10.2 mm) diameter
- DIMENSIONS (POWER MODULE) 3.66" (92.9 mm) long,
0.74" (18.9 mm) diameter
- OUTPUT CONNECTOR (POWER MODULE) Integral 3-pin XLRM-type
- CABLE 6.0' (1.8 m) long (permanently attached to microphone), 0.10" (2.6 mm) diameter, 2-conductor, shielded cable with TA3F-type connector
- ACCESSORIES FURNISHED AT8418 UniMount® microphone instrument mount; AT8538 power module; soft protective pouch
- AUDIO-TECHNICA CASE STYLE M12
|
|
 |
 |
|
|
|
 |
 |
 |
